95T TreadmillsAssembly Instructions
Congratulations...and welcome to the world of The following Parts Identification Listing and the step by step assembly procedureshave been assembled t
TOOLS REQUIRED FOR ASSEMBLY... #2 Phillips screwdriver; 4mm, 5mm, 8mm Allen Head Drivers (T-Bar recommended)PARTS DESCRIPTION1 UPRIGHT Qty: 1 2 M12
IMPORTANT!DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTSNEEDED TO COMPLETE THE INSTALLATION ARE LOCATED IN
8. Secure the ERGO CROSSBAR of the HANDRAIL/BRIDGEASSEMBLY (5) to the CONSOLE BRACKET (6) using threeSCREWS (31) and three WASHERS (8).NOTE: ROUTE THE
14. Locate the BOTTOM COVER (13). Remove the ACCESSDOOR (N) and set it aside. Drop the POLAR CABLE (O)through the opening. Install the BOTTOM COVER to
21. Install the LEFT REAR ENDCAP (21) using two SCREWS (22).Tighten the SCREWS securely. Do not overtightenthe SCREWS.NOTE: BE SURE THE LOCATOR CLIP I
IMPORTANT!CHECK THE BELT EDGE UNDER THE TREADMILL TO VERIFY THE BELT DOES NOT INTERFERE WITH LIFE-SPRING BRACKETS AND THE BELT IS PROPERLY SET WITHIN
Komentáře k této Příručce